BLOCK WORK ACCESSORIES

Ladder Mesh

Ladder Mesh

Ladder Type Mesh consists of two parallel side rods with cross rods welded at 400 mm, thus forming a Ladder Configuration and used where vertical reinforcement is present.

Ladder Truss Type Mesh

Ladder Truss Type Mesh

Truss type Mesh consists of two side rods welded to a continuous diagonally shaped cross-rod forming a truss design with alternating welds not exceeding 200 mm.This is used on single Wythe walls where vertical reinforcement is not present.

G.I & SS Wall Ties Or Hold Fast

G.I & SS Wall Ties Or Hold Fast

Wall Ties are specially designed to secure wall skins and framework together to provide structural integrity through various forms of movement and force.

G.I & SS Movement Ties

G.I & SS Movement Ties

Movement Ties are designed to restrain masonry against lateral wind loads,allowing a horizontal expansion or contraction and used where masonry restrained to steel work and in long span masonry. Ties are held in the brick work and the de bonding sleeve in the plain end of the tie will allow the movement. A 10 mm gap is provided at the end between the tie and the sleeve in order to allow the expansion or contraction.Ties are provided with 6 mm holes or 6 x 18 mm slots as appropriate for fixing.

G.I & SS Cavity Wall ties (Strip Ties)

G.I & SS Cavity Wall ties (Strip Ties)

Cavity wall ties are designed to secure two leaves of a cavity wall to each other allowing them to act as structurally one. These are made in strips or wires to be embedded in the masonry of two walls.The drip feature in the tie prevents the moisture travelling across the cavity.Ties are provided with 6 mm holes or 6 x 18 mm slots as appropriate for fixing.

SS Cavity Wall ties (Wire Type)

SS Cavity Wall ties (Wire Type)

Cavity wall ties are designed to secure two leaves of a cavity wall to each other allowing them to act as structurally one. These are made in strips or wires to be embedded in the masonry of two walls.The drip feature in the tie prevents the moisture travelling across the cavity.Ties are provided with 6 mm holes or 6 x 18 mm slots as appropriate for fixing.